searched and searched but issue remains.
#21
Registered User
I have a squeak, too. Seems like it's related to my unbalanced tire going around. It's my R/R spring bushings/shackle. Does it squeak when ya rock the truck?
Last edited by combatcarl; 01-01-2014 at 07:54 AM.
#23
Registered User
Thread Starter
Join Date: Jul 2012
Location: Seattleish
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
1.) my 4runner does not have a center section on the rear driveline
2.) just tried rocking the truck about with my body weight and no sounds whatsoever
3.) How would I go about lubing the speedo cable?
2.) just tried rocking the truck about with my body weight and no sounds whatsoever
3.) How would I go about lubing the speedo cable?
Last edited by KaptainKoolz; 01-01-2014 at 09:52 AM.
#24
Registered User
Join Date: Apr 2011
Location: punxsutawney, pa
Posts: 312
Likes: 0
Received 0 Likes
on
0 Posts
unplug it off the back of the speedometer(you can reach up between the gas and brake pedal and unplug it) unthread the fitting off the transfer case and you can pull the cable out of the housing, get some grease in your hand and lightly coat the whole thing in grease and reinsert it.
#28
Registered User
Thread Starter
Join Date: Jul 2012
Location: Seattleish
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the help gents, the entire rear axle was rebuilt in june to the sum of over 2k, obviously i was taken to school and someone only replaced the passenger seal and bearing.
#33
Registered User
Thread Starter
Join Date: Jul 2012
Location: Seattleish
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
I took it back to the shop that rebuilt the rear axle last summer, they said the driver side half shaft spun the bearing and it grooved the shaft somehow which is what caused the play, they are going to replace the shaft and bearing/seal. Hopefully I wont have anymore problems, I am hoping to sell this truck soon
#34
Registered User
I took it back to the shop that rebuilt the rear axle last summer, they said the driver side half shaft spun the bearing and it grooved the shaft somehow which is what caused the play, they are going to replace the shaft and bearing/seal. Hopefully I wont have anymore problems, I am hoping to sell this truck soon
#37
Registered User
Thread Starter
Join Date: Jul 2012
Location: Seattleish
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Yea im quite convinced that the 3vze is a pile, it would be a tad better with a manual trans but the 3vze-auto combo sucks. The 06 would be an "in family" trade of sorts, its high miles (150k+) but I have done all maintenance on it since 50K or so miles. I would only have to surrender my 2nd gen.
Thread
Thread Starter
Forum
Replies
Last Post
montanatruck
86-95 Trucks & 4Runners
15
02-26-2017 07:07 AM