R151f turbo transfer case mated to V6 R150
#1
Registered User
Thread Starter
R151f turbo transfer case mated to V6 R150
Hi everyone, I have the opportunity to buy a 23 spline R151f gear drive transfer case, and I have a few questions. I have researched but have a few outlying questions before I make the purchase.
.
Note: I plan to run this as a single case.
.
.
Note: I plan to run this as a single case.
.
- The R151f transfer case has a 4.5" forward shift according to Marlin. My transmission accepts a 4" forward shift. Can I swap my 4" forward shift from my current transfer case to the turbo transfer case? Is this even necessary? Or do I need to convert it to top shift?
- I'll need an adapter kit. I believe this kit will do the trick. Can anyone confirm?
- I plan to install a single 4.7 gear into this transfer case. When the time comes for dual cases, can I easily make this my rear case? If so, I assume when I buy another transfer case that's a 21-spline, and make it the front case, I'd need to upgrade it to 23 spline since I'm using the 23 spline adapter kit.
Last edited by yota_terror; 06-16-2019 at 01:08 PM.
#2
Registered User
Thread Starter
Well, for anyone else that may have these questions, I called Marlin Crawler and here are the answers.
1. You will need to convert it to top shift. Adapter plates don't accept any kind of forward shift.
2. Yes
3. Yes
1. You will need to convert it to top shift. Adapter plates don't accept any kind of forward shift.
2. Yes
3. Yes
Thread
Thread Starter
Forum
Replies
Last Post
dixiemuddtoy
Engine Swaps
0
03-02-2019 09:28 PM
zombie_stomp
86-95 Trucks & 4Runners
4
09-12-2018 07:00 PM
FS[PacNorWest]: R151f transmission, transfer case, and cross member - Idaho
yardleyto
Engines - Transmissions
1
06-07-2014 10:22 PM
augie
The Classifieds GraveYard
0
01-28-2008 01:00 PM