new cylinder head question
#1
Registered User
Thread Starter
new cylinder head question
I am replacing with a new head from engnbldr and am moving the threaded studs from the intake and exhaust from the old head.
Question - is the process to thread them in finger tight and while torquing the nuts on later allow them to seat properly, or is there something specific to do when threading them in?
Anyone have any ideas? thanks
Question - is the process to thread them in finger tight and while torquing the nuts on later allow them to seat properly, or is there something specific to do when threading them in?
Anyone have any ideas? thanks
Thread
Thread Starter
Forum
Replies
Last Post
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
15
07-14-2020 08:35 PM
jasonty
Pre 84 Trucks (Build-Up Section)
41
12-23-2018 01:00 PM
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM