i need help!!!!!!!!
#23
Registered User
Join Date: Mar 2008
Location: Temecula Valley, CA
Posts: 12,723
Likes: 0
Received 4 Likes
on
4 Posts
peek in and see if the ring ends are touching each other. and the end gaps should not be all lined up. they should rotate, either clockwise or anti-clockwise, about 120 degrees apart from one ring to the next
#24
#27
Registered User
Thread Starter
Join Date: Jan 2008
Location: Temecula CA
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
ya i put them off set i was saying i got them all to the way the book said. sry about the mix up. but i cant find the box the new rings came in so i cant tell you the name but im checking the ring gap right now
#29
Registered User
Thread Starter
Join Date: Jan 2008
Location: Temecula CA
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
ya, this is my first rebuild and im fliping out cause i dont want any thing to go wrong with it. and every thing look ok as far as the rings and bearings. thanks guys and i will start to look off that sticky
#30
#31
Registered User
did you get the rod caps mixed up by accident??
i would install #1 piston, then turn the crank, install #2, then turn the crank..etc. that way you can find out where the problem is!
i would install #1 piston, then turn the crank, install #2, then turn the crank..etc. that way you can find out where the problem is!
Last edited by TOYOTA 1; 07-09-2008 at 03:38 PM.
#33
#34
Registered User
Thread Starter
Join Date: Jan 2008
Location: Temecula CA
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts