Damged Ring... Options
#1
Registered User
Thread Starter
Join Date: Oct 2007
Location: Lexington, SC
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
Damged Ring... Options
I guess i worked longer than i should last night. I was putting the pistons in my 22re and buggers up an oiler ring. Just looking at what my options are. The ring is not broke, but bent a but. I checked around local and couldnt find anone with rings in stock. I have to ask the obvious, could it work if i bend it back into shape? But I doubt thaqt is a good thing. So anyone have any left over Enginebuilder .20 over oiler rings? I guess i can go drink the entirne weekend, feeling pretty bummed .
#2
Registered User
iTrader: (1)
Just have Engnbldr overnight you a new box of 22re rings. I don't think they cost that much.
This reminds me of the time I was doing valve stem seals on a Tercel. I had just as many seals as needed and I screwed one of them up and had to take like a 4 hour break to track a new one down, drive across town, and pick it up so I could finish the stupid project!
This reminds me of the time I was doing valve stem seals on a Tercel. I had just as many seals as needed and I screwed one of them up and had to take like a 4 hour break to track a new one down, drive across town, and pick it up so I could finish the stupid project!
#3
Registered User
Thread Starter
Join Date: Oct 2007
Location: Lexington, SC
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
Yeah it looks like that is what is going to happen. I could bent the ring to make it flat but it is still out of round. No need to score the cylinder walls. Oh Well. Looks like i will be ordering them on monday. Oh well.
Thread
Thread Starter
Forum
Replies
Last Post
TheBFA
Solid Axle Swaps, All Years
8
02-15-2020 06:55 AM
kbpickens
Newbie Tech Section
5
10-02-2015 03:37 PM