A couple problems trying to figure out
#1
Registered User
Thread Starter
A couple problems trying to figure out
Hi all any help is appreciated.
I have a 94 extracab 4x4 3.0L v6
1. High idle around 1100-1200rpm cold or hot all the time tried adjusting idle speed screw no change.
2. All of a sudden when I put my high beams on my headlights go out completely. But sometimes they work like normal.
3. When I turn sharp like backing out of a parking spot usually to the right I get a clanking or cracking sound from the front left. I replaced both front axels with new ones when I first got the truck in July because of a safety to register it. When it was on the hoist last month for a new starter I noticed the lower ball joint rubbers were torn, could it be my ball joints?
Again thank for any help.
I have a 94 extracab 4x4 3.0L v6
1. High idle around 1100-1200rpm cold or hot all the time tried adjusting idle speed screw no change.
2. All of a sudden when I put my high beams on my headlights go out completely. But sometimes they work like normal.
3. When I turn sharp like backing out of a parking spot usually to the right I get a clanking or cracking sound from the front left. I replaced both front axels with new ones when I first got the truck in July because of a safety to register it. When it was on the hoist last month for a new starter I noticed the lower ball joint rubbers were torn, could it be my ball joints?
Again thank for any help.
Thread
Thread Starter
Forum
Replies
Last Post
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
07-06-2015 01:20 PM