22RE Surfacing
#1
Registered User
Thread Starter
22RE Surfacing
i had my motor bored over .20 over?
the machin guy also said he had to surface the deck and he took off roughly 5thousands.
do i need to worry about the pistons and valves hitting?
what should i do?
any opiniopns would be greatly appreciated.
sorry if this has been covered before. (i am not the best search-er)
the machin guy also said he had to surface the deck and he took off roughly 5thousands.
do i need to worry about the pistons and valves hitting?
what should i do?
any opiniopns would be greatly appreciated.
sorry if this has been covered before. (i am not the best search-er)
#3
Registered User
Thread Starter
thats what i thought but my buddy swears uo and down that it is going to change everything and that i need some kind of spacer.
anything i should be aware of?
anything i should be aware of?
#5
Registered User
Thread Starter
i see. thanx for the help guys. i just want everything to be done right so when i put it in my truck, i will be good for another 300,000 haha..
it had 380,000 on it when i pulled the motor with several headgasket jobs.
i just want to do it the right way the first time around.
it had 380,000 on it when i pulled the motor with several headgasket jobs.
i just want to do it the right way the first time around.
#6
Contributing Member
I would look into a head shim if any thing mine was done .010 and I got the copper head shim just to be safe $29 bucks now beats a couple hundred down the road
Thread
Thread Starter
Forum
Replies
Last Post
themightykhoner
86-95 Trucks & 4Runners
2
08-11-2015 07:37 PM
matrad
99+ Tundra, 00+ Sequoia, 98+ Land Cruiser/LX470
2
08-08-2015 03:00 PM