Crap, I bent my yoke
Jun 25, 2013 | 04:41 PM
#1
Thread Starter
Registered User
Joined: Dec 2012
Posts: 100
Likes: 0
Crap, I bent my yoke
So I spent the day making a hydraulic press out of scrap metal. It worked out great...
I was pressing the 3 Ujoints out of the driveshaft of my 1982 Toyota Pikcup/ RV.
Well, on one of the shorter yokes (With ears for the Ujoint cups on one side, and a plate with 4 hole son the other) isn't exactly flat, and pressing the joint out, I bent one of the ears inward about 1.6MM.
Is that something I can bend back?
I have been trying to find a replacement yoke but I can't seem to find one anywhere.
I was pressing the 3 Ujoints out of the driveshaft of my 1982 Toyota Pikcup/ RV.
Well, on one of the shorter yokes (With ears for the Ujoint cups on one side, and a plate with 4 hole son the other) isn't exactly flat, and pressing the joint out, I bent one of the ears inward about 1.6MM.
Is that something I can bend back?
I have been trying to find a replacement yoke but I can't seem to find one anywhere.
Thread
Thread Starter
Forum
Replies
Last Post
justdifferentials
Just Differentials
5
Jun 13, 2022 07:40 PM
