Replacing the RS3000 system?
#1
Contributing Member
Thread Starter
Join Date: Aug 2002
Location: High Point NC
Posts: 2,063
Likes: 0
Received 0 Likes
on
0 Posts
Replacing the RS3000 system?
How complicated would it be to replace the stock RS3000 with either a Viper or Clifford alarm/remote start 2way system? Or would I be better off leaving it up to the pros and apying someone to do the install?
I feel confident in my electrical skills but just a bit concerned about messing with the stock system. Thanks in advance.
I feel confident in my electrical skills but just a bit concerned about messing with the stock system. Thanks in advance.
#2
Registered User
Originally Posted by Stump1883
How complicated would it be to replace the stock RS3000 with either a Viper or Clifford alarm/remote start 2way system? Or would I be better off leaving it up to the pros and apying someone to do the install?
I feel confident in my electrical skills but just a bit concerned about messing with the stock system. Thanks in advance.
I feel confident in my electrical skills but just a bit concerned about messing with the stock system. Thanks in advance.
removing the RS3000 is a piece of cake, esp if you have the install manual. its on my writeup at http://www.4runners.org/articles/rs3000 i just worked backwards from the install manual, check off each step, plugged the harnesses back in, and then fired it up to test if everything was kosher. even if you are slow as a turtle, shouldnt take you more than 1 hour.
i dont know about vipers or cliffords, but a few of us have installed commando 870s. it was the first time i installed an alarm. three of us did it at the same time, compared notes, etc. it took us all a few days. sorry, no writeup for obvious reasons. but if you are comfy pulling apart some wires, soldering, etc and can identify the proper wires, it is not too difficult.
bob
#3
Contributing Member
Thread Starter
Join Date: Aug 2002
Location: High Point NC
Posts: 2,063
Likes: 0
Received 0 Likes
on
0 Posts
Awsome, I think I'll tackle that soon then, give myself a Christmas present off of the tution reimbursement check coming soon.
The system you three installed, did that have the remote start feature? That's what I want more than anything(I'm tired of going outside to warm the car before I leave).
The system you three installed, did that have the remote start feature? That's what I want more than anything(I'm tired of going outside to warm the car before I leave).
#4
Contributing Member
Join Date: Jul 2002
Location: SLC, UT
Posts: 5,862
Likes: 0
Received 0 Likes
on
0 Posts
I took out the RS3000 system and installed the same alarm that bob did. The RS wasn't too bad to take out, just follow the wiring harness and disconnect the harness.
Install was pretty easy thanks to Bob, it only took me a couple of hours.
Install was pretty easy thanks to Bob, it only took me a couple of hours.
Thread
Thread Starter
Forum
Replies
Last Post
TURBOrunnerNM
86-95 Trucks & 4Runners
4
07-22-2015 11:01 AM
Avenged
95.5-2004 Tacomas & 96-2002 4Runners
4
07-09-2015 07:55 AM
skoti89
Offroad Tech
3
07-08-2015 12:05 AM
Vargntucson
95.5-2004 Tacomas & 96-2002 4Runners
0
07-04-2015 12:15 PM