Where to start with this bench seat?
#1
Where to start with this bench seat?
In my 1993 pick 2x4 22RE 5 speed M-Trans 220k
Needs to go, are there websites who sell the seat covers I can get the foam localy or should I look into getting new bucket seats?
#3
#6
I am in San Diego, issue is this is my only car so i can not really have no seat for the few days it will take to get the other one redone.
i am fine with spending 100-200$ on this or going to bucket seats
Trending Topics
#8
then send the original to a shop to be redone i am not in the mood to start drilling holes into my pickup.
#9
Registered User
Join Date: May 2011
Location: SANTA ANA, CA
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
#12
std cabs have no back seats, after some long thought bout it. if it sags downward in the back just make a bar. to raise it up or level it bolt it and roll. but i miss the gap for space with bench seats .
Last edited by yotarover; 09-15-2011 at 05:38 PM.
#14
Registered User
If any of you want to make your factory bench seat a little firmer use a piece of carpet behind the springs. I did this on my 87 and it make a world of a difference.
To the OP, sometimes you can find a factory OEM seat cover on Ebay. They fit the best and most universals.
James
To the OP, sometimes you can find a factory OEM seat cover on Ebay. They fit the best and most universals.
James
#15
If any of you want to make your factory bench seat a little firmer use a piece of carpet behind the springs. I did this on my 87 and it make a world of a difference.
To the OP, sometimes you can find a factory OEM seat cover on Ebay. They fit the best and most universals.
James
To the OP, sometimes you can find a factory OEM seat cover on Ebay. They fit the best and most universals.
James
Thread
Thread Starter
Forum
Replies
Last Post
icentropy
86-95 Trucks & 4Runners
4
07-09-2015 02:12 PM
Steezy96yota
86-95 Trucks & 4Runners (Build-Up Section)
1
07-06-2015 10:00 AM