Kiff

Just bought a x-over steering setup minus the drag link. Guy told me the arms were tapered for the chevy tre. I am going to make my own drag link on the lathe, wondering if I can use FJ80 TRE, if they are similar? or will I have to go Chevy on 1 end, and Stock on the other, to match my stock pitman arm.

waskillywabbit

iTrader: (-1)

and search Pirate FAQ as this has been covered before.

Kiff

Is it possible to ream the stock pitman arm out? enough material?

AxleIke

This question makes no sense.

Of course its possible to ream it. You can ream anything with a hole in it.

Is there enough material? For what? A 20" hole? No. A 9/16" hole, yes. A 4" hole? No.

Kiff

sorry, ream for a chevy tre.

waskillywabbit

iTrader: (-1)

Kiff,

In the quest for you to modify your vehicle I would suggest you click the link below and do a lot of reading.

http://www.pirate4x4.com/forum/showthread.php?t=459180

PS. Don't ask the questions there you have asked here or there will be reaming you don't enjoy.