Adding a York compressor post swap.
#1
Registered User
Thread Starter
Adding a York compressor post swap.
Any of you guys done it on your 3.swapped motors into a 3rd gen pickup or 2nd gen Runner?
I just bought a York compressor and a Pacific Northwest bracket setup for the 3.4 motor and was curious to see any pictures of a swapped motor with one installed.
Mounts to the top of the alternator bracket and after starring at he space, it amazes me that it gonna go in there. It's gonna be very tight.
I just bought a York compressor and a Pacific Northwest bracket setup for the 3.4 motor and was curious to see any pictures of a swapped motor with one installed.
Mounts to the top of the alternator bracket and after starring at he space, it amazes me that it gonna go in there. It's gonna be very tight.
#4
Registered User
Thread Starter
I have everything but the tanks. My buddy is going to knock me out a tank, oil catch, and a manifold from stainless at work but I have to wait for him to have the time. Sometimes free sucks.
I could install the compressor and such now, but I have just been waiting. Not looking forward to moving the battery again.
I could install the compressor and such now, but I have just been waiting. Not looking forward to moving the battery again.
Last edited by dntsdad; 03-04-2014 at 06:41 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Flying91
86-95 Trucks & 4Runners (Build-Up Section)
45
04-11-2024 04:39 PM
skoti89
Offroad Tech
3
07-08-2015 12:05 AM