Retard/Advance Timing After Header Install
#1
Retard/Advance Timing After Header Install
Hey all,
Couldn't find a topic discussion on this issue.
From what I was I told, after installing a full exhaust system (headers:No Cat:2 1/4" piping:Exhaust muffler before the axle:Tail pipe out behind the rear driver fender well) that you gotta "retard" the timing.
I read some issues, but alls they were talkin' about was advancing the timing.
I have a 1993 Toyota 22-RE Xtracab Deluxe 5speed.
I've installed Doug Thorley headers
Removed the Cat
2 1/4" piping before the O2 sensor sits and after the O2 sensor location
Flowmaster Exhaust
Tail pipe out.
Should I adjust the IAC sensor or actually adjust the timing.
Be sure to include details like KOE-OFF or KOE-ON
thanks
Couldn't find a topic discussion on this issue.
From what I was I told, after installing a full exhaust system (headers:No Cat:2 1/4" piping:Exhaust muffler before the axle:Tail pipe out behind the rear driver fender well) that you gotta "retard" the timing.
I read some issues, but alls they were talkin' about was advancing the timing.
I have a 1993 Toyota 22-RE Xtracab Deluxe 5speed.
I've installed Doug Thorley headers
Removed the Cat
2 1/4" piping before the O2 sensor sits and after the O2 sensor location
Flowmaster Exhaust
Tail pipe out.
Should I adjust the IAC sensor or actually adjust the timing.
Be sure to include details like KOE-OFF or KOE-ON
thanks
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthEast]: Mercury Villager Fan & DCC Fan Controller
coryc85
Misc Stuff (Vehicle Related)
6
09-09-2015 06:24 AM