Rod directions
#1
Registered User
Thread Starter
Rod directions
ok guys...i need some help again..
since i WAS going to get my block bored...i didnt worry about numbering the pistons....
so now i have 4 un-numbered pistons..and 4 new rods...i know which way to face each piston..(with the mark facing the front of the engine)
but im not exactly sure which way to face the rods...2 of my new rods have a mark on them like what it talks about in the haynes..but the other two have nothing...all of the oil passages on each rod all face the same direction..so i need to know if i have it right..so..which way do i face the rods?
now back to the pistons...does it matter which piston goes in which cylinder????
i feel like such an idiot...lol
since i WAS going to get my block bored...i didnt worry about numbering the pistons....
so now i have 4 un-numbered pistons..and 4 new rods...i know which way to face each piston..(with the mark facing the front of the engine)
but im not exactly sure which way to face the rods...2 of my new rods have a mark on them like what it talks about in the haynes..but the other two have nothing...all of the oil passages on each rod all face the same direction..so i need to know if i have it right..so..which way do i face the rods?
now back to the pistons...does it matter which piston goes in which cylinder????
i feel like such an idiot...lol
#2
Registered User
meh, dont feel like an idiot i would have done the same thing, not exactly sure but it shouldent matter wich piston is where as long as their facing the same direction, and the rods should all face the same way right???hopefully some 1 els will chime in
Thread
Thread Starter
Forum
Replies
Last Post
kawazx636
The Classifieds GraveYard
34
10-06-2021 03:03 PM
live4soccer7
84-85 Trucks & 4Runners
3
05-11-2016 06:52 PM
primordialbeast117
86-95 Trucks & 4Runners
11
12-19-2015 12:23 PM
83yotastockR
86-95 Trucks & 4Runners (Build-Up Section)
11
11-10-2015 06:54 AM