3.0 head bolts
#1
Registered User
Thread Starter
3.0 head bolts
Om so I am reinstalling the heads on my 3.0 for the second time. While we were turning the last 90* the bar slipped a bit and turned to about 96*. My question is, is it better to leave it as is? Or back it off a few degrees to make them all even?
Any help is appreciated.
Jason
Any help is appreciated.
Jason
#6
Four for torquing them all the same and call it good. I turned mine all down about a 1/16 of a turn past 90° on the final turn when I installed them the last time. I haven't had any issues since doing so either.
Thread
Thread Starter
Forum
Replies
Last Post
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM