80 amp ignition fuse holder broken
#1
80 amp ignition fuse holder broken
Hey, been a while since I have posted. But here it goes
In trying to unblolt the fuse from the fuse holder (i did lower it out of the fuse box) The plastic bit that held the bolts stripped. So the fuse holder is useless. Is there a decent place to replace this or does anybody have a recommendation for an aftermarket 80 amp fuse holder and or breaker setup.
85 Toyota Pickup 22r
In trying to unblolt the fuse from the fuse holder (i did lower it out of the fuse box) The plastic bit that held the bolts stripped. So the fuse holder is useless. Is there a decent place to replace this or does anybody have a recommendation for an aftermarket 80 amp fuse holder and or breaker setup.
85 Toyota Pickup 22r
#3
Registered User
I would bypass it, and buy a maxi fuse holder and 80 amp maxi fuse. https://www.delcity.net/store/Maxi-F...20group%20%231.
either that, or rob the holder and fuse from a wrecking yard or parts truck.
either that, or rob the holder and fuse from a wrecking yard or parts truck.
#4
I would bypass it, and buy a maxi fuse holder and 80 amp maxi fuse. https://www.delcity.net/store/Maxi-F...20group%20%231.
either that, or rob the holder and fuse from a wrecking yard or parts truck.
either that, or rob the holder and fuse from a wrecking yard or parts truck.
The following users liked this post:
old87yota (04-09-2019)
#5
Registered User
#6
Registered User
Have a look at 'ANS' type fuses and holders. They come in ratings of 50, 60, 80 amps and higher. You can get a nifty little fuse holder for them too. They're about 2" long and about 3/8" wide and 3/16" thick. I used them to fuse the alternator and after the battery disconnect switch for all loads (not the starter) on my 83.
Thread
Thread Starter
Forum
Replies
Last Post
buckz6319
86-95 Trucks & 4Runners
2
03-15-2016 01:54 PM
alva22re
86-95 Trucks & 4Runners
11
02-20-2016 04:21 PM