1983 crankshaft pulley problem
#1
Registered User
Thread Starter
1983 crankshaft pulley problem
I just recently got my 22r rebuilt and yesterday we started putting the motor back together when it was time to put the crankshaft pulley back on we ran into a problem. The pulley wouldn't go in all the way as if the pump drive spline was stopping it. We have no idea what the problem can be all I know is we went from a single row to a dual row timing chain can this have anything to do with the pulley not properly fitting?
#3
crank pulley
I also ran into this problem it seemed the crank pulley have about 1/4 inch left and would not go any further. I put everything back in the way I found it for the oil pump. I was originally replacing a seal but now dont know what to do.. How would the key be placed on the balancer?would it be in the grove or slot or???
#4
Oil pump drive gear not installed correctly/not all the way installed...?
If I'm not mistaken the oil pump drive spline/gear is smaller on the dual row timing chain engines(Pre-84) than the single row timing chain engines.
If I'm not mistaken the oil pump drive spline/gear is smaller on the dual row timing chain engines(Pre-84) than the single row timing chain engines.
#5
Im gonna get into it tm and see wants going on.. I was thinkinking the same thing but then it started to get dark.. THANKS FOR THE REPLY
Well see wat happens Ill post results tm
Well see wat happens Ill post results tm
#6
Registered User
Thread Starter
That's exactly what was wrong with mine. Since I switched to the dual chain I had to buy a smaller spline because the original was just a little to big making my pulley not fit right.
Thread
Thread Starter
Forum
Replies
Last Post
dinks07
95.5-2004 Tacomas & 96-2002 4Runners
0
07-15-2015 05:34 PM