YotaTech Forums
Lube these before you start, located inside the wheel well, under the covers if you have them.
Lube these before you start, located inside the wheel well, under the covers if you have them.
0 2017/02/01 05:35:04
In bolt this once free from debris
In bolt this once free from debris
0 2017/02/01 05:34:58
To the left this is where the dirt collects, just to the right under my vacuum pump is a wire harness clip
To the left this is where the dirt collects, just to the right under my vacuum pump is a wire harness clip
0 2017/02/01 05:34:54
This is the brake master cylinder fluid wire, it clips to the CC sub assembly. Sorry bad pic. I broke mine.
This is the brake master cylinder fluid wire, it clips to the CC sub assembly. Sorry bad pic. I broke mine.
0 2017/02/01 05:34:50
Pry up the tabs on the can
Pry up the tabs on the can
0 2017/02/01 05:34:46
Don't forget your match mark, if you do you'll have to rotate the can and might damage the diaphram
Don't forget your match mark, if you do you'll have to rotate the can and might damage the diaphram
0 2017/02/01 05:34:41
Here is the diaphragm without the shell
Here is the diaphragm without the shell
0 2017/02/01 05:34:35
Remove the bottom cover to expose the filters. These will need replaced they will disentigrate when removed. You don't want them to enter the valves they cover.
Remove the bottom cover to expose the filters. These will need replaced they will disentigrate when removed. You don't want them to enter the valves they cover.
0 2017/02/01 05:34:31
And remove the diaphragm to expose the return spring and valve coils.
And remove the diaphragm to expose the return spring and valve coils.
0 2017/02/01 05:34:26
Spring orientation, final wrap just above the screw.
Spring orientation, final wrap just above the screw.
0 2017/02/01 05:34:21
Another angle, the spring seats between the screws and the housing and is a tight fit.
Another angle, the spring seats between the screws and the housing and is a tight fit.
0 2017/02/01 05:34:17
Coil checks out
Coil checks out
0 2017/02/01 05:34:13
Coil checks out
Coil checks out
0 2017/02/01 05:34:08
Here we check the valves with a bit of straw, hose, or in this case some shrink-wrap (Napa part number shown)
Here we check the valves with a bit of straw, hose, or in this case some shrink-wrap (Napa part number shown)
0 2017/02/01 05:34:01
Minor cracking of the diaphragm. I coated it with permatex black and worked it into the crevices then gave it a topcoat
Minor cracking of the diaphragm. I coated it with permatex black and worked it into the crevices then gave it a topcoat
0 2017/02/01 05:33:52
0 2017/02/01 05:30:14
0 2017/02/01 05:30:11
Fuel pump diagnostics connector
Fuel pump diagnostics connector
0 2017/02/01 05:30:08
0 2017/02/01 05:30:03
0 2017/02/01 05:29:59
These are the diagnostics connectors.
These are the diagnostics connectors.
0 2017/02/01 05:29:54
0 2017/01/29 23:20:13
17410C
17410C
0 2017/01/28 23:32:37
Backside of the bellhouse
Backside of the bellhouse
0 2017/01/28 23:31:09
0 2017/01/28 23:30:46
End of the arrow, iirc they gum up.
End of the arrow, iirc they gum up.
0 2017/01/28 20:53:57
0 2017/01/27 21:52:06
Glue under trim
Glue under trim
0 2017/01/27 10:52:06
Glue down here
Glue down here
0 2017/01/27 10:50:17
Seam, middle lower glue and fill this
Seam, middle lower glue and fill this
0 2017/01/27 10:49:23
0 2017/01/26 15:35:52
0 2017/01/26 11:42:59
0 2017/01/26 06:49:57
0 2017/01/25 23:27:53
0 2017/01/25 05:24:46
0 2017/01/24 18:58:31
0 2017/01/24 18:57:46
3vz dash gauge water temp sender. The right side red arrow
3vz dash gauge water temp sender. The right side red arrow
0 2017/01/24 18:39:50
0 2017/01/24 18:33:16
0 2017/01/23 14:35:00