toyota rear into jeep?
Jul 1, 2005 | 07:49 PM
#2
Registered User
Joined: Apr 2004
Posts: 635
Likes: 1
From: Warrenton, VA
A YJ Wrangler or a TJ Wrangler?
A YJ should be no problem, assuming the two axles are about the same width. Just pull the crappy Dana 35 out, cut and reweld the Toyota spring perches to match the spacing of the Jeep's leaf springs, and bolt it on. You would get a pretty big lift by doing this since you'll be going from spring under to spring over.
The brake lines would need a little bit of attention 'cause the Jeep stuff is probably SAE and the Toyota lines are metric.
I know I've seen where people swapped a Toyota axle into a Cherokee, but haven't heard of doing it in a Wrangler.
A YJ should be no problem, assuming the two axles are about the same width. Just pull the crappy Dana 35 out, cut and reweld the Toyota spring perches to match the spacing of the Jeep's leaf springs, and bolt it on. You would get a pretty big lift by doing this since you'll be going from spring under to spring over.
The brake lines would need a little bit of attention 'cause the Jeep stuff is probably SAE and the Toyota lines are metric.
I know I've seen where people swapped a Toyota axle into a Cherokee, but haven't heard of doing it in a Wrangler.
Jul 2, 2005 | 12:14 AM
#4
Contributing Member
Joined: Oct 2004
Posts: 1,078
Likes: 0
From: Bellingham, Washington and Ketchikan, Alaska
You guys know of any writeups of doing a toyota rear in a wrangler?
Last edited by Yamaha+Toyota=Fun; Jul 2, 2005 at 12:15 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Gravel Maker
RuffStuff
2
Jul 6, 2015 07:43 PM
cchinny
General Electrical & Lighting Related Topics
6
Jun 25, 2015 08:11 PM
