How hard would it be? If I got the seats from the same generation would the holes line up or would some drilling be involved? Thanks for the input.

 

i put sr5 truck buckets from an 84 into my 85 truck ... the mounts were there, but i had to drill a hole... it was easy though..... also had to drill new holes for the seatbelts... but it wasnt a problem

 

It won't be hard at all (if you stick to same year / generation)... The stock (single) bench seat uses a subset of the holes needed for buckets / 60-40's. In other words, more than enough holes (in the right places) are already there. Your only concern should end up being how to block off a couple of extra holes.

 

you want to put a bench in and take out your buckets? if you were nearby i'd swap ya straight across