When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
1986 Toyota Pickup, 4- wheel drive, Auto transmission, manual locking hubs: Front passenger axle has radial play and a score/gouge mark in the axle's splines. What do I need to replace?
your pictures don't show the "score/gouges" in the splines.
when you took it apart, was the small snap ring that rides in the groove just to the inside of the splines still there? and the washer behind it? how about the 12mm bolt at the end of the stub?
Last edited by wallytoo; Jun 30, 2022 at 05:34 AM.
your pictures don't show the "score/gouges" in the splines.
when you took it apart, was the small snap ring that rides in the groove just to the inside of the splines still there? and the washer behind it? how about the 12mm bolt at the end of the stub?
Getting old, sucks. I forgot that i removed a snap ring from where i referenced the score in the splines. The snap ring, washer and 12mm bolts were installed.
so, how much radial play with those installed? if the locking hub slides over the axle splines without much difficulty, the splines can't be too bad. if that's the case, i wouldn't worry about any gouges/scores; but depending on how much play in/out might need to be solved...
Jun 30, 2022 | 05:27 AM
what he said.
