So it turns out that my new door panels are a little too thick to allow the original window crank to be mounted. Has anyone else run into this? It there another factory crank that has a longer spline section that I could use instead?

 

Mine had springs behind the panel to push it out flush, you might remove them to gain a little room if you have them.

 

No...no springs on mine.

 

There should be a washer/trim piece that fits behind the handle that keeps it from rubbing.

 

Where did you find new door panels? I've been looking for some. If online, can you please provide a link?

Thanks, Rick

 

They were built by the guy doing my stereo...so not factory.