Notices
86-95 Trucks & 4Runners 2nd/3rd gen pickups, and 1st/2nd gen 4Runners with IFS

Rough idle after AFM repair

Thread Tools
 
Search this Thread
 
Old Apr 30, 2013 | 03:18 PM
  #1  
asumtneer's Avatar
Thread Starter
Registered User
 
Joined: Apr 2013
Posts: 3
Likes: 0
Rough idle after AFM repair

So I just spent the last couple hours troubleshooting my no start problem. Finally figure out how to put my AFM back together and it started back up. Problem is now a rough idle. Any chance this could still be AFM related? I had no issues with rough idle before I messed up the AFM. Any help would be appreciated. Thanks

92 Yota 4x4 truck
5 speed 22re with 140k miles
Reply
Old Apr 30, 2013 | 03:30 PM
  #2  
Philbert's Avatar
Registered User
iTrader: (2)
 
Joined: Dec 2009
Posts: 2,159
Likes: 7
From: Pleasanton, CA - SF Bay Area
Are you throwing a check engine light? If so, diagnose it and share what you get?

What have you done to the truck recently (since it last ran)? Senders for temp coolant (and their wiring) can get mucked up, causing bad idle (I'm going through this now after my head job - messed up a thermo sensor so the ECU doesn't know when my engine it warmed up and it stays in cold start mode.
Reply
Old Apr 30, 2013 | 03:33 PM
  #3  
asumtneer's Avatar
Thread Starter
Registered User
 
Joined: Apr 2013
Posts: 3
Likes: 0
No CEL. I was stupid and pulled the 2 screws out of the AFM and disconnected/broke some stuff on the inside. I soldered the connections back, but am afraid that it still may be the AFM that is causing the issue.
Reply
Old Apr 30, 2013 | 03:45 PM
  #4  
Philbert's Avatar
Registered User
iTrader: (2)
 
Joined: Dec 2009
Posts: 2,159
Likes: 7
From: Pleasanton, CA - SF Bay Area
try testing the AFM:
http://www.4crawler.com/4x4/CheapTricks/AFM/index.shtml

You're not providing a lot of other variables to help diagnose over the internet

Good luck
Reply
Old Apr 30, 2013 | 07:11 PM
  #5  
ksti's Avatar
Registered User
 
Joined: Dec 2011
Posts: 1,388
Likes: 8
From: CA, Until TSHTF!
Originally Posted by asumtneer
No CEL. I was stupid and pulled the 2 screws out of the AFM and disconnected/broke some stuff on the inside. I soldered the connections back, but am afraid that it still may be the AFM that is causing the issue.
Kinda sounds like you toasted it.
There is a thread from someone who repaired theirs IIRC
But in most cases if you have (some stuff) broke, it probably will never work properly again.

Like suggested from "Philbert" test it to be sure.
Reply
Old Apr 30, 2013 | 07:34 PM
  #6  
ksti's Avatar
Registered User
 
Joined: Dec 2011
Posts: 1,388
Likes: 8
From: CA, Until TSHTF!
dual post
Reply
Old May 1, 2013 | 02:24 PM
  #7  
asumtneer's Avatar
Thread Starter
Registered User
 
Joined: Apr 2013
Posts: 3
Likes: 0
UPDATE: so I switched out the AFM and it solved the problem. Luckily my Dad had a 92 that is out of service and I was able to nab another part off of it. Thanks for the help fellas.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Sleaker
86-95 Trucks & 4Runners
17
Aug 26, 2020 06:03 AM
Eggslinger
86-95 Trucks & 4Runners
22
Jun 8, 2019 03:32 PM
montanatruck
86-95 Trucks & 4Runners
15
Feb 26, 2017 07:07 AM
Sidherish
86-95 Trucks & 4Runners
1
Aug 2, 2015 01:42 PM
tomczaksdiesel
86-95 Trucks & 4Runners
0
Jul 26, 2015 10:35 PM




All times are GMT -8. The time now is 07:56 PM.