I am using the complete repair guide found online, and everything is fine til the point where you "install and tighten 2 bolts to remove the flange". What two bolts? Are these the same that are removed earlier in the steps?

 

You don't have auto hubs.

You have ADD.

What are you trying to do?

:wabbit2:

 

Replace wheel bearing. I have the 6 nuts on the wheel hub and 2 open bolt holes which is apparently for popping the hub free. The problem is I don't know what bolts to use. Is there a defined size so I can just go get some?

 

You are trying to get the drive flanges off?

Pics would help.

:wabbit2:

 

The first step of this page. There is nothing unusual about the job thus far except the bolt issue. Everything else is standard.

 

M8x1.25

:wabbit2:

 

Sweet! Thank you sir.