Hey do you guys know where to get patch panels for 1st gen 4runner rear fenders. Only place I can find is the one in Canada...thx

 

You might try this thread:
https://www.yotatech.com/forums/f116...rs-etc-221646/

 

I could not find any replacement sheet metal any where near me but ended up finding a junk 4runner and the guy let me cut out what ever I needed for $40.

 

you could try us

http://www.toyotafiberglass.com also has repair panels .. stamped steel replacements not hand formed like the other place .. We are also working on some NEW fiberglass replacements -- comming soon


.

 

+1 for Slacker. Great guy, great products. I talked to him and wanted to buy his panel, but in my case I needed such a large piece that the shipping was super expensive. I got lucky to find that parts truck.

 

Stamped steel repair panels? I've been wondering/hoping if/when you'd make some! I'm all ears!

I just checked your site and didn't see any listed. Next summer I'll be looking for cab corners for my '94, maybe rockers, too. What steel panels will you be offering? This would be a lot easier than forming my own, which is what I was planning to do.

 

hey slacker, you guys have rocker panel replacements by chance? For under an 87 pickup single cab door?

 

Try http://car-part.com for a place to cut some patch panels for you. There are lots of junkyards that don't belong to this site though. I'm with YotaRob though, the best bet is to cut your own at a pick-n-pull. Maybe you can ask for a cordless reciprocating saw and metal blades for Christmas!

 

we only have the 95-95 4runner repair panels .. there very expencive , and we are actually phasing them out because of rising costs .. I kind of doubt we'll be doing any stamping because of high costs .. lets face it , most toyota truck people just dont want to pay for that quality . We are doing some fiberglass .. and maybe even some repair panels .



.