Reed Valve 86 22r
Jul 15, 2010 | 12:15 PM
#1
Thread Starter
Registered User
Joined: May 2010
Posts: 25
Likes: 0
From: Pacifica, CA
Reed Valve 86 22r
I recenty replaced the head on my carbed 86 PU.
During the re-build, I did strip the reed valve that sits below the carb. Unfortunately, during re-assembly I got distracted and am not sure if I put the valve plate back in the correct way. It fits facing forward and back. It has an arrow stamped on the plate.
I’m not sure if this would cause any problems – anyone know which way this goes?
Thanks
During the re-build, I did strip the reed valve that sits below the carb. Unfortunately, during re-assembly I got distracted and am not sure if I put the valve plate back in the correct way. It fits facing forward and back. It has an arrow stamped on the plate.
I’m not sure if this would cause any problems – anyone know which way this goes?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
foampile
03+ 4Runner/GX470, & 05+ Tacomas
1
Dec 18, 2022 01:29 PM
Jcrawl94
84-85 Trucks & 4Runners (Build-Up Section)
10
Oct 24, 2015 04:34 PM
