Hey guys new to the forum and I guess you get tired of this one but here goes. I'm going to do a 2.5 lift on a 91 4runner SR5 V6 that has 31" X 10.5" X 15's on it. I want to use the stock 15" mags and put on some 33's. I wanted some suggestions for the lift kit and will I have any trouble with the 33's rubbing? Any reccomendations for tires would be helpful. Not going offroad much it's more for looks. I have been looking at Continental Sprotiva AT's. Anybody been using them. I appreciate any help you can give me. These 4X4's ain't my thing. I'm an old school muscle car drag racer. This is for my kids truck!

 

See below for some ideas:
- http://www.4crawler.com/4x4/ForSale/...it.shtml#FAQ10

 

This will help as well. And if your not sagging too much 33's will fit on stock.

https://www.yotatech.com/forums/f116...-guide-155339/

 

I used to run a 92 4runner that ran with Bj spacers and ome cruiser coils. 33x12.5 Goodyear Mt/r only rubbed at full lock,all i did was trim the lower bumper.

 

Thanks for the help guys. I looked into the Continental Sportiva's and was told that they were produced for STS and some other chains and are no longer available. I was told that they were reasonable and worked well. Does anybogy have any treccomendations? I might consider 33" X 10.5" X 15" as well as the 33"s.
Thanks again.

 

i have a 91 on some after market wheels running 32x11.50x15's the wheels offset stick out a bit more than the stock wheels (i want the stock wheels) and this causes to rub sometimes in reverse, i have no lift.