Engine wiring is sorted (aftermarket ECU) just need to figure out lights/washers etc, I am trying to determine what pins are what so I can re wire. I still have stock connectors but the rest of the loom is pretty haggard and I am not paying 250 for a replacement. There is no AC/heater (will be an electric heater later for rego), no emissions control, no stock engine control so just wiring this section will get me out of trouble.

I have some diagrams out of a Haynes with continuity charts but I am not sure how to figure out what pin is what etc. Looking for mainly input pins, after that I should be able to find the relevant outputs by using the switch.

If anyone wants to take a squiz at the diagrams and help out it would be much appreciated.