hi i was thinking off building a rear tube bumper at my school and i have no way off getting my truck there so i was wondering if eny one had eny measurements off a bumper they built and eny pictures and it is on a 3rd gen 4runner

 

any body

 

there are tons of pictures of 3rd gen bumpers on here. plate and tube.

 

Ya I know but I was wondering if eny one built one and still had measurements off the one that built and a picture off it

 

any one?

 

I didn't even write any measurements down when I built mine. I don't know how good of an idea it is to build a bumper without having the vehicle there. Unless you have built a few and have jigs set up you are asking for trouble even if you do have measurements. Perhaps if you can not bring the yota to the welder you could take measurements on your vehicle then start making templates and have things ready to go together then once that is ready to go you could bring in your runner in for final mock up. In case you are looking for ideas here is the link to pictures of mine.https://www.yotatech.com/f191/dannom...thread-188973/

 

Ok thanks for the info