I'm trying to clean up my wiring and am trying to figure out how to get accessories to turn on and off with the ignition. There are several that I have in mind so I would just like to power a whole fuse block via ignition.

Do I just tap into a fuse on the stock block and power my accessories fuse block with it? Do I use the ignition to activate a realy to turn on my accessory block?

Here is what I want turned on with ignition:

-inline noise filter for cb
-aux headlamps
-aux rear light
-air compressor
-aux cig lighter
-subwoofer

Any suggestions?

 

The subwoofer should turn on with the cd player and amp. One positive fused to battery, one remote and a ground, then the amp should cut on and off with the sub.

 

I would use the ignition to turn on a relay to power the auxiliary fuse block. I used one of these fuse blocks from Painless, it has constant hot and ignition hot circuits

http://www.painlessperformance.com/w...&SearchAll=4x4 OffRoad

 

Of Course! Duh! I should have thought of that. Thanks Eric.

The sub is already on the remote. good call, Sean.

 

Now if I could only figure out my internal regulator conversion.