Problem with 1993 4-Runner (won't start)
Oct 8, 2003 | 09:52 PM
#1
Thread Starter
Registered User
Joined: Oct 2003
Posts: 108
Likes: 0
Problem with 1993 4-Runner (won't start)
I was helping my buddy tune-up his 1993 4-Runner (3.0 V6 EFI)
We swapped his plugs and wires (he didn't initially change the cap and rotor).
He tried to start the truck but no dice!! I checked the coil wire and it didnt' spark against a screwdriver.
We replaced the coil and it still won't start.
What's next??
I think he is going to replace the distributor. Someone suggested that it might be the camshaft position sensor inside the distributor.
Please advise.
BTW: I have a 2002 Tacoma 4x4 TRD. Loving it!!
We swapped his plugs and wires (he didn't initially change the cap and rotor).
He tried to start the truck but no dice!! I checked the coil wire and it didnt' spark against a screwdriver.
We replaced the coil and it still won't start.
What's next??
I think he is going to replace the distributor. Someone suggested that it might be the camshaft position sensor inside the distributor.
Please advise.
BTW: I have a 2002 Tacoma 4x4 TRD. Loving it!!
Last edited by P. Bauer; Oct 8, 2003 at 10:04 PM.
Oct 12, 2003 | 09:01 AM
#2
Contributing Member
Joined: Jun 2002
Posts: 7,454
Likes: 10
From: Eastern NC
Battery? wires connected properly? Did it run before?
Oct 12, 2003 | 01:29 PM
#3
Contributing Member
Joined: Oct 2002
Posts: 1,997
Likes: 0
From: Fountain Valley, CA (so cali)
Originally posted by Paul H.
Did it run before?
Did it run before?
Thread
Thread Starter
Forum
Replies
Last Post
aciorba23
99+ Tundra, 00+ Sequoia, 98+ Land Cruiser/LX470
1
Jun 29, 2015 04:18 PM
