Its still there......the ticking that i thought was rod bearings
May 15, 2009 | 06:27 PM
#1
Thread Starter
Registered User
Joined: Apr 2009
Posts: 61
Likes: 0
From: Atlanta, GA
Its still there......the ticking that i thought was rod bearings
the ticking that i thought was rod bearings. well i did the bearings today and after the worst knuckle buster of my life (thought i needed stitches) and everything all said and done the tick is still there
caled up my buddy the yota tech and he said its either a worn out bore or loose wrist pin. i will say this, the new bearings and re torquing everything did quiet it a bit. so anyways, going to drive it till it blows up and slap in something else when it happens. 
on a side note. i was shocked at how simple it was to do the bearings GOOOOOOOOO TOYOTA!!!!!
caled up my buddy the yota tech and he said its either a worn out bore or loose wrist pin. i will say this, the new bearings and re torquing everything did quiet it a bit. so anyways, going to drive it till it blows up and slap in something else when it happens. on a side note. i was shocked at how simple it was to do the bearings GOOOOOOOOO TOYOTA!!!!!
Last edited by waskillywabbit; May 15, 2009 at 08:36 PM.
Thread
Thread Starter
Forum
Replies
Last Post
