When I bought my 84 4runner it was stripped of all paneling inside, molding, rubber etc.. The P.O. was putting the back window up and down by connecting 2 wires to the motor and touching the wires to an 18v dewalt drill battery. I do not want to do that. The wiring is there all the way to the back from the switch in the center console which I just installed. I plugged it all in, and no power. I have been trying to figure it all out, I have checked out 4crawler's site with the window help here: http://www.4crawler.com/4x4/CheapTri...leshootingTips and have gotten some great information. I also read somewhere that in the drivers side kick panel there is supposed to be a circuit breaker? Relay? Anyways, I have take a picture of my fuse box and circled some areas in question. I have a feeling that the circled spots are missing relays/breakers that have to do with the rear window. Anyone know what goes in these spots and what is controlled by them?

 

This might help: http://www.4crawler.com/4x4/4R_TechI...tml#Electrical

I also have an '85 FSM but not in front of me. The owner's manual will have a photo and description if you have one.

 

I have a haynes and haven't found a pic or description of the circled spots in question yet. I will look again though. Thank you.

 

Ok it's all sorted out. I installed a dpdt toggle switch and bypassed all the relays and junk. Thanks guys.

 

do you know where the relay is

 

http://www.4crawler.com/4x4/CheapTri...leshootingTips

 

Power window relay location and circuit breaker just below that:
http://www.4crawler.com/4x4/CheapTri...l#PowerWindows