Well I spent a bit of time with a new hand powered pipe bender working on a front bumper for my little 2wd because i riped the silly plastic stock one off. It might be a little over kill but I like it and it only cost me 50 bucks and some work. I will post up some pics later tonight so yall can take a look and tell me what you think.

 

Looks good. I'm not sure about the color though.

 

Um... I think it looks good as well.

 

hmmm.... black on black? taken at night with no flash.....?

 

Thats Bad Ass I Just Wish The Color Was A Bit BRIGHTER

 

This Thread Is Worthless Without Pics

 

Here are some pic of my new bumper, sorry i couldnt post the pics earlyer I was at school and didnt have the pics.

 

Still needs to be brighter.

 

dude thats sweet! i love how you bent the tube around like that...

 

 

I like the mesh. not a huge fan of straight tube but I like the mesh.

 

Tube looks good, front stinger is a bit largish though.

 

I like it how did you mount it to your frame?

 

for mounting i used some angle iron to set the spacing then I welded about 8" of 1.5" square tubing and drilled a hole through the frame and bolted it down nice and tight

 

I have mixed feelings on the matter. But good work. I'd like to make my own tube front bumper someday this gives me a few idears.

Hey what do you call a dear with now eyes? No Idear. Get it, get it....Sorry. Lack of sleep drove me to it.

 

how bout a good side view? and straight on?
just to get a better idea

 

Here are some different angles that you asked for