Tacoma/4Runner guys...need some measurements
Jan 2, 2007 | 01:13 PM
#1
Thread Starter
Registered User
Joined: May 2002
Posts: 2,479
Likes: 2
From: Cincinnati Ohio
Tacoma/4Runner guys...need some measurements
I need some rear drive shaft measurements of 95.5 to 02 4Runners and standard cab Tacomas. Measure from diff flange to t-case flange. Also note 4/6cy and auto/manual trans.
Thanks!
Thanks!
Last edited by Adam F; Jan 4, 2007 at 12:12 PM.
Jan 4, 2007 | 03:16 AM
#4
^ that was my '96 4runner.
My brothers TRD '01 3.4 5pd Tacoma has a two piece drive shaft thats has it's own crossmember (learn something new everyday). The entire unit is 67" I.D. from flange to flange. The rear shaft is 36" I.D. flange to flange. The front part/shaft can be measured different ways so i didn't bother but it's around 25".
My brothers TRD '01 3.4 5pd Tacoma has a two piece drive shaft thats has it's own crossmember (learn something new everyday). The entire unit is 67" I.D. from flange to flange. The rear shaft is 36" I.D. flange to flange. The front part/shaft can be measured different ways so i didn't bother but it's around 25".
Thread
Thread Starter
Forum
Replies
Last Post
kawazx636
The Classifieds GraveYard
34
Oct 6, 2021 03:03 PM
live4soccer7
84-85 Trucks & 4Runners
3
May 11, 2016 06:52 PM
83yotastockR
86-95 Trucks & 4Runners (Build-Up Section)
11
Nov 10, 2015 06:54 AM
