Toyota parts. Huge salvage yard. You want it? I have it!
#401
I need a red driver seat for my 86.5 4runner.
Also red driver fender.
Do you have either?
Also good shift boot for same truck. 5spd 4x4
Also red driver fender.
Do you have either?
Also good shift boot for same truck. 5spd 4x4
Last edited by YotaSnap; Oct 16, 2013 at 11:34 PM.
#402
Thread Starter
Registered User
iTrader: (6)
Joined: Apr 2009
Posts: 1,756
Likes: 12
From: high ridge
Where are you located for shipping? Does color matter on the tail gate? and i wouldn't sell it if it had rust. What sas axle are you looking for? When asking for 4.88's do you want them for your ifs rig or after you get the "sas axle" Go back through your request please and be specific. Also if you are shipping this stuff keep in mind an axle will be expensive to ship so be sure you are not wasting time by asking for things you will not purchase due to shipping constraints. Thank you.
#404
Looking for door lock actuators for a 95 4runner. Both Front doors.
Also the little handle for reclining the drivers seat on same vehicle. in tan.
Thanks
Also the little handle for reclining the drivers seat on same vehicle. in tan.
Thanks
#405
1993 4runner
I am looking for a power antenna for a 1993 4runner shipped to 55346
Thanks,
Glenn
Thanks,
Glenn
#406
Perhaps a strange request...but could you get any of these clips/fasteners
Maybe it's not worth your time... Oh ummm 87 pickup 4wd they are the things that hold the splash shields up..

This one holds the wiring harness to the skeleton that the fenders bolt on to and holds it a few other places.

Last but not least....these whole flaps that protect the engine from dirt and what not. All of them both sides.
Maybe it's not worth your time... Oh ummm 87 pickup 4wd they are the things that hold the splash shields up..

This one holds the wiring harness to the skeleton that the fenders bolt on to and holds it a few other places.

Last but not least....these whole flaps that protect the engine from dirt and what not. All of them both sides.
#407
Looking for a center console for a 1983 sr5 pickup 4x4 shipped to 91761 thanks
Last edited by Abraham Contreras; Oct 25, 2013 at 03:22 PM.
#408
center console lid/center console for 98 to do cupholder ugrade
year: 1996
Make: Toyota
model: 4Runner
trim package: sr5 sport seat package
Color if applicable interior/exterior: tan vinyl
Make: Toyota
model: 4Runner
trim package: sr5 sport seat package
Color if applicable interior/exterior: tan vinyl
#409
#411
Might be a long shot
Like the title says, it might be a long shot, but I am looking for some early 90's SR5 wheels, I'm in Texas and these are hard to find here. Any help would be appreciated.
94 Xtra Cab 3VZE
Thanks.
94 Xtra Cab 3VZE
Thanks.
#412
I'm looking for a l52 shifter does anyone know where to find one new or used? Also will my l45 shifter work on my l52?
Last edited by duckmaster88; Oct 19, 2013 at 09:10 AM.
#413
I am looking for a rear axle assembly 98-02 Tacoma w/diff lock no abs 4.30 ratio. Must have working actuator included. Would take a 4.10 if that's all you have available but prefer the 4.30
I will want a photo of the motor housing/casing please also.
I will want a photo of the motor housing/casing please also.
Last edited by NEKExplorer; Oct 19, 2013 at 02:59 PM.
#414
Got my part the other day. Great condition, and even gave me the screws too. Thanks! I'll be getting more parts from you soon.
#416
I need a shift solenoid in a bad way for a 89 4cyl. pickup auto tranny. Its the one on the drivers side, just above the pan on the exterior. It has the two bolt pattern with a single wire feed. I know Im new here but been on ebay for years with 100% positive rating. Here is the link with a picture of it I posted in the 86-95 truck forum. Shipping would be to Carriere, MS 39426 Pm and thanks for any help!
https://www.yotatech.com/forums/f116...t-part-274332/
https://www.yotatech.com/forums/f116...t-part-274332/
Last edited by Mudslicks; Oct 25, 2013 at 05:01 PM. Reason: forgot shipping location
#418
I'm looking for air intake parts for a 22re.
I need everything before the air mass sensor. I'm not totally clear which parts these are since they aren't on my truck at all.
Toyota lists:
Air box
Two air intakes
Cooling duct
I can't tell from the diagram if these are two different air intake systems or if the stock setup comes with all four parts.
I need everything before the air mass sensor. I'm not totally clear which parts these are since they aren't on my truck at all.
Toyota lists:
Air box
Two air intakes
Cooling duct
I can't tell from the diagram if these are two different air intake systems or if the stock setup comes with all four parts.
#419
Thread Starter
Registered User
iTrader: (6)
Joined: Apr 2009
Posts: 1,756
Likes: 12
From: high ridge
I'm looking for air intake parts for a 22re.
I need everything before the air mass sensor. I'm not totally clear which parts these are since they aren't on my truck at all.
Toyota lists:
Air box
Two air intakes
Cooling duct
I can't tell from the diagram if these are two different air intake systems or if the stock setup comes with all four parts.

I need everything before the air mass sensor. I'm not totally clear which parts these are since they aren't on my truck at all.
Toyota lists:
Air box
Two air intakes
Cooling duct
I can't tell from the diagram if these are two different air intake systems or if the stock setup comes with all four parts.

#420
98620
I am converting from a "cold" air intake (read a K&N attached to the air mass sensor) back to a stock airbox and intake so that I can hook up a snorkel.
Are there two stock air intake configurations or are all four parts I mentioned (1, 3, 7, 8 in diagram) needed?
I am converting from a "cold" air intake (read a K&N attached to the air mass sensor) back to a stock airbox and intake so that I can hook up a snorkel.
Are there two stock air intake configurations or are all four parts I mentioned (1, 3, 7, 8 in diagram) needed?


