Crank Position Sensor/Gear Pictures.
#1
Registered User
Thread Starter
Crank Position Sensor/Gear Pictures.
This should be the Crank timing belt gear too. I need pictures.
im currently talking to a company out of Australia, about being a distributor in the US for them. They make a complete tuning piggy back specifically for the 3.4 5vzfe.
We are currently trying to figure out how similar or disimlar the aussie 3.4 is to the US/CAN one.
she asked me this question and im trying to find an answer for her.
Please confirm the Crank signal on your vehicle to ensure it is the same as what we've previously seen, which should be 36-2 Reluctor / Inductive
I'm assuming this refers to the crank position sensor and the amount of teeth on the crank gear.
for obvious reasons im not going to give out the name of the piggy back yet but. Probably by the end of this week i will know more and beable to fill the rest of the details in. im hoping to at the very min. to beable to offer a nice group buy for yota tech.
im currently talking to a company out of Australia, about being a distributor in the US for them. They make a complete tuning piggy back specifically for the 3.4 5vzfe.
We are currently trying to figure out how similar or disimlar the aussie 3.4 is to the US/CAN one.
she asked me this question and im trying to find an answer for her.
Please confirm the Crank signal on your vehicle to ensure it is the same as what we've previously seen, which should be 36-2 Reluctor / Inductive
I'm assuming this refers to the crank position sensor and the amount of teeth on the crank gear.
for obvious reasons im not going to give out the name of the piggy back yet but. Probably by the end of this week i will know more and beable to fill the rest of the details in. im hoping to at the very min. to beable to offer a nice group buy for yota tech.
Last edited by thefallman; 07-30-2007 at 07:06 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Dennisx2
General Electrical & Lighting Related Topics
0
08-04-2015 01:26 PM