FS[MidWest]: Kansas City, mo Part out sale.. seats panels frames, dash
#84
Registered User
Do you have the mid 80’s 2 spoke steering wheel,and the blue male plug that goes to the column? Thanks Jim Do you know where a topper for 90-95 short bed extended cap pickup?
#86
Registered User
Thread Starter
Hey, sorry didn't see you message. I'll have to check if I have that steering wheel laying around
I probably have the harness plug.
And I have a lot of a Grey dash, what parts ?
I probably have the harness plug.
And I have a lot of a Grey dash, what parts ?
#87
actually, what I need is the three dash vent grills, or will consider complete right side dash, depending on shipping also a driver side door handle (pull)
Last edited by Jginger; 04-21-2024 at 05:49 AM.
#88
Registered User
Thread Starter
there should be 4 vents.the missing one on the passenger side you gotta take out to get the dash apart. I'm looking for it.
the door hand? Or are you refuring to the comfy arm rest door handle
#90
Registered User
Thread Starter
sure do, the buttons on the side is off a 82 2x4 pu, and the one centered is an 85 4runner(if my memory serves me right). They are both 15.25" diameter
#92
Registered User
Thread Starter
Your good, when you said pull I was thinking that's what you ment.
So here's the 2 middle vents and the passengers side vent, (they absolutely suck to get out if the dash is installed, make sure you stick them in right)
The arm rest door pulls fit driver/passenger. With a 7" hole center. (I think these are for a p/u. The ones on my 4runner appear to be 5 3/8"
So here's the 2 middle vents and the passengers side vent, (they absolutely suck to get out if the dash is installed, make sure you stick them in right)
The arm rest door pulls fit driver/passenger. With a 7" hole center. (I think these are for a p/u. The ones on my 4runner appear to be 5 3/8"
#99
Registered User
Thread Starter