hey i'm hunting for a yota to hold me over till i get my pickup done in the spring.i want a 22re but i found a 95 v6 auto in pretty decent shape but it needs a bearing and seal where the front driveshaft goes in the t-case. how big a job is this i wouldnt be doing it myself because of the weather but would i be looking at alot to get a shop to do it?could there be more wrong with the tcase?buddy said the 4x4 works fine.

 

Honestly if you go to a car wash and take a couple pieces of cardboard It shouldn't take more than 20-30 minutes!! would need the socket to pull the shaft a socket as big as the seal and a big screw driver and hammer. just be sure to drive the seal in straight.

 

What does a carwash have to do with it?

 

car wash covered fairly dry ground.....wind break......