adhesive for new intake manifold gasket?
#1
Registered User
Thread Starter
Join Date: Dec 2009
Location: Huntington Beach, CA
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
adhesive for new intake manifold gasket?
do i need to use an adhesive when installing new intake manifold, chamber and egr valve gaskets? if so what kind? thanks
#4
YotaTech Milestone-Two Millionth Post
22re? no.
i cleaned the heck out of the surfaces with acetone and kinda just pinned them(i think there's a stud or so) on there and all went well.
i will say....i had my EGR on before my intake gasket and the gasket had a piece on it for the EGR but it was too late......so my EGR is on with a smear of black RTV
i cleaned the heck out of the surfaces with acetone and kinda just pinned them(i think there's a stud or so) on there and all went well.
i will say....i had my EGR on before my intake gasket and the gasket had a piece on it for the EGR but it was too late......so my EGR is on with a smear of black RTV
Thread
Thread Starter
Forum
Replies
Last Post
ksmudrunner99
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
6
08-07-2015 06:46 PM
whereAreMyPants
86-95 Trucks & 4Runners
2
07-22-2015 03:32 AM
adheasive, adhesive, ahesive, apply, gasket, gaskets, glue, installation, installing, intake, kind, lower, manifold, quickdrying, yotatech