Taurus Fan Question
#1
Registered User
Thread Starter
Join Date: Dec 2005
Location: Roanoke, VA
Posts: 571
Likes: 0
Received 0 Likes
on
0 Posts
Taurus Fan Question
I have looked up a few write-ups on the taurus fan swap into my truck. I was wondering if yall think it would be better to have the thermostat or just a switch and watch the temperature. Most of the aftermarket e-fans you buy come with or have the option for a thermo to come with it so I'm thinking that this would be the best way to run this setup, but ........
How much extra do they cost and how hard to install ?
How much extra do they cost and how hard to install ?
#2
Contributing Member
How are you going to watch the temp? I hope it's not the stock temp gauge, because by the time those read hot you're already way too hot.
Get an automatic controller set-up of some kind.
DCC makes some of the best controllers around: http://www.dccontrol.com/index.htm Very easy to install, no need for relays, complete kit with excellent instructions, and good tech support.
Get an automatic controller set-up of some kind.
DCC makes some of the best controllers around: http://www.dccontrol.com/index.htm Very easy to install, no need for relays, complete kit with excellent instructions, and good tech support.
Last edited by mt_goat; 02-12-2007 at 05:29 AM.
Thread
Thread Starter
Forum
Replies
Last Post
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
15
07-14-2020 08:35 PM
FS[SouthEast]: Mercury Villager Fan & DCC Fan Controller
coryc85
Misc Stuff (Vehicle Related)
6
09-09-2015 06:24 AM