I'm getting ready to replace u-joints in my 88' 4runner and my buddy recommended buying spicer u joints. I see in a previous thread (below), the part #s for corresponding Moog parts, I'd need 3 #285s and 2 #513s I think. Can anybody provide me equivalent spicer u joint #s I would need? I'm sure we could use Moog too, but since he's helping me do most of this, I tend to just defer to his suggestions on the parts.

#####
#####

I own an '88 4Runner SR5 with 22RE, 4WD and a 5 speed manual transmission. It has 365,000 miles and just recently developed a periodic clang from the rear when I take off from a stop. I also have noticed a subtle grinding noise which I can hear and feel through the gas pedal. I feel almost certain one of my U-joints is going out. My intention is to replace all of the U-joints, but am uncertain of the parts I need. Based on looking at ROCK Auto's web site it appears I need 4 U-joints, but 2 different types:

3 Moog/Precision #285 (greaseable Super Strength) for the
1. rear drive shaft at rear axle
2. front drive shaft at front axle
3. rear drive shaft at transmission

1 Moog/Precision #513 (Premium) for front drive shaft at transfer case

I have 3 questions.
Am I correct regarding the number and types of U-joints?
Does it matter that the U-joint for the front drive shaft at the transfer case is not greaseable?
Are there any other parts I will need to order to replace the U-joints?

Never replaced U-joints before, any advice would be welcomed. Thanks
Dave
########
########

 

all three u-joints (spiders) should be the same, and still available through several vendors, including oem parts (toyota parts deal)

toyota parts deal

or spicer 5-1510x if you want spicer.

the double cardan spiders/ujoints are:

spicer 5-2532x (you might verify this one elsewhere) or,

precision 513