Rear window won't go down - on a bind or rusted
#1
Rear window won't go down - on a bind or rusted
My switch is fine. Replaced it with one I knew worked. It goes down a couple of inches and stops. The windshield wiper is not the issue. So...having got those things out of the way...
I really think on the driver's side that its so rusted that it's jammed. I'm fairly certain I can't do anything about it without pulling the mechanical parts out, but I'm not sure how to go about doing that without totally taking it apart and being unsure how it goes back together. If I was going to replace the rails, how would I go about doing it? Is there an exploded view of the rear door someone could point me to? The Rear window tricks page is not helpful for my particular situation. Any ideas?
I really think on the driver's side that its so rusted that it's jammed. I'm fairly certain I can't do anything about it without pulling the mechanical parts out, but I'm not sure how to go about doing that without totally taking it apart and being unsure how it goes back together. If I was going to replace the rails, how would I go about doing it? Is there an exploded view of the rear door someone could point me to? The Rear window tricks page is not helpful for my particular situation. Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
BeMiceElf
Misc Stuff (Vehicle Related)
7
10-10-2015 09:40 PM
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM
FS[SouthEast]: 1st Gen 4Runner Slider Window, Driver Side
coryc85
Misc Stuff (Vehicle Related)
0
07-06-2015 04:07 AM