"A" Pillar > Interchangeability
12-04-2011, 12:02 PM
#1
Registered User
Thread Starter
Join Date: Dec 2005
Location: 4431OHIO
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
"A" Pillar > Interchangeability
Hey all
Quick question....
Can the "A" pillar from an extra cab be used in a regular cab?
I see the extra cab trucks have an additional "O-˟˟˟˟˟" grab handle on them
VS.
The regular cab trucks are blank.....
The reason I ask is the area above the window
The single cabs pillar trim is just pillar and stops.........
The extra cab has pillar AND above the front window as 1 piece
Any help would be
Quick question....
Can the "A" pillar from an extra cab be used in a regular cab?
I see the extra cab trucks have an additional "O-˟˟˟˟˟" grab handle on them
VS.
The regular cab trucks are blank.....
The reason I ask is the area above the window
The single cabs pillar trim is just pillar and stops.........
The extra cab has pillar AND above the front window as 1 piece
Any help would be
12-04-2011, 12:32 PM
#2
Registered User
Join Date: Oct 2009
Location: Pgh, PA
Posts: 263
Likes: 0
Received 0 Likes
on
0 Posts
you mean the handle by the windshield? Pop the plastic off and check for threaded holes. I know my 4runner is pre threaded for a overhead grab handle for the driver (assuming due to the same shell being used on RHD trucks and it being simpler to use 1 form to make them all) Was a great use of a extra j/y handle I had
Thread
Thread Starter
Forum
Replies
Last Post
94toyy
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
12
09-14-2015 06:18 AM
icentropy
86-95 Trucks & 4Runners
7
09-10-2015 05:03 AM
