Panhard bracket didn't change axle?
#1
Registered User
Thread Starter
Join Date: Jun 2011
Location: Queen Creek, AZ
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
Panhard bracket didn't change axle?
I have my LC coils and BJ spacers on, everything looks good. But I put on the 4inch panhard drop bracket, the panhard sits almost perfectly horizontal again, but the axle did not come back towards the driver side at all. Its still sticking to the passenger side by a good inch. How is it possible that it didnt move if I installed the 4 inch bracket and the bar is horizontal now?
#3
Registered User
Thread Starter
Join Date: Jun 2011
Location: Queen Creek, AZ
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
Yea, I drove it about 20 miles. It DEFINITELY drives much better, the rear end isnt swaying all over the road every time I hit a bump like before, but after getting under there and checking it out and measuring, the axle is in the same place it was before.
Thread
Thread Starter
Forum
Replies
Last Post
Flying91
86-95 Trucks & 4Runners (Build-Up Section)
45
04-11-2024 04:39 PM
jasonty
Pre 84 Trucks (Build-Up Section)
41
12-23-2018 01:00 PM