Like almost every Toyota pickup owner, i was unimpressed with the cupholder. So when I saw my buddys factory cupholder in his s10, i figured I could make it work. I took the bracket off the bottom of the s10 seat frame and welded it to the bottom of my seat frame. Easy, cheap, effective, and looks factory.

The chevrolet setup


just the bracket


where I welded it to the seat frame



another close up



and tomorrow I'll post a pic of what it all looks like installed. It looks factory, is removable for cleaning, and fits right between the drivers and passengers seat cushions.

 

heres a pic of how it looks installed, and i dyed the cupholder to match my interior

 

Just added that to my mod list. Looks great!

 

That's clean, if you wouldn't have told me I would have said it was stock. Too bad my truck doesn't have space in the middle, I hate those cupholders, especially when I have to run the heater when I've got a soda in the cupholder (warm soda is disgusting)!

 

What did you use for the dye?

 

Thanks! I used duplicolor vinyl dye from autozone. It isn't a perfect match, but its very close. I used it on my 4runner door pockets as well.