Headlight/wiper tree assembly wiring harness 86 4runner DLX
#1
Registered User
Thread Starter
Headlight/wiper tree assembly wiring harness 86 4runner DLX
Anyone know what the separate dual yellow wire connector that comes off the wiper selector switch is? My low beams didn't work when I bought the truck and the previous owner was nice enough to hook me up with a junkyard replacement of the tree assembly (aka combination switch), however, the replacement was/is missing this independent connector with the yellle wires. I already had everything pulled apart when o realized so I just went ahead and replaced and left the yellow wires disconnected. I can't for the life of me figure out what feature has been lost in the process. I still seem to have intermittent wipers and the adjustments work as do my low beams and high beams and all turn signals as well. I looked at the wiring diagrams I have access to and I can't seem to figure out what those two wires are supposed to go to. Any ideas? It's the connector in the pictures that my finger is touching.
Last edited by outdoorjunky; 03-08-2018 at 08:04 AM.
#2
Registered User
Thread Starter
The only thing I can think this connector might have done is trigger the wipers on when I press the mist button but if that's all it does I really don't care. Am I on the right track?
Thread
Thread Starter
Forum
Replies
Last Post
FS[PacSouthWest]: Rear Wiper Assembly, Complete Except for Wiper Blade
RAD4Runner
Misc Stuff (Vehicle Related)
1
01-06-2018 04:03 PM
bend
86-95 Trucks & 4Runners
1
10-14-2012 03:50 PM
igotit
General Electrical & Lighting Related Topics
3
03-26-2012 06:26 PM