I know a good fab guy who is going to do me up some sliders cheap.

I have a 2nd gen SR5 and was wondering how long should I make them? 60" like allpro? or like 65-66" to cover the whole thing?

also how long should I make it from the main bar to the side of the kick out? also I'm going to have them made with a 30 degree cant (see below) so I guess that figures into how wide they should be.

I'll have him make them like this


I'm also open to other ideas on how to design these if people have any idea on a better way to do it.

 

Have you seen my sliderz from Badland Bumpers?
More info on them can be found on my homepage in the Mods section.

I just measured mine, and they are 63" x 7.5" deep not counting the tubes that attach it to the frame.
http://www.pnw4runners.com/runs/41203/7.jpg

They match up with the Bushwacker flares pretty nice.

 

thanks corey.. good info

 

Thanks...
Here are a few close-ups from my site showing the angle of them, and the half moon cutouts in the pinch weld made with a plasma torch.

http://pnw4runners.com/tando/sliderz8.jpg

http://pnw4runners.com/tando/sliderz7.jpg