My 1st gen face lift
#31
Registered User
Thread Starter
Join Date: Jan 2009
Location: Eugene Oregon
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Didn't get much accomplished this weekend. Just some more added to front end and got most the cab back together.
Winch control up on the wheel well.
Winch control up on the wheel well.
#33
Registered User
Thread Starter
Join Date: Jan 2009
Location: Eugene Oregon
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Finally got around to starting the cage a little different than most
Planning on 45 the front instead of bending to keep it closer to the body.
Front flexed out (springs aren't broke in yet)
Planning on 45 the front instead of bending to keep it closer to the body.
Front flexed out (springs aren't broke in yet)
#35
Very nice. I wish you'd have cleaned up that T-case before you put it in BTW did you buy or fab that adapter for the master cylinder? And what kind of brake upgrade have you done with the rest of the system?
#36
Registered User
Thread Starter
Join Date: Jan 2009
Location: Eugene Oregon
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
The Adapter is a Sky's adapter. Brakes are all stock toyota lines with a blazer master cyl. Sky hard line adapters to toy lines. Toyota Dual Diaphragm brake booster out of a v6 toyota. I thought bout cleaning up the T cases, but was gunna be too much work and they'll only get dirty again
#40
Registered User
Thread Starter
Join Date: Jan 2009
Location: Eugene Oregon
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys! The axles haven't received anything yet, but soon will be 5.38's front an rear, lockrite front and welded rear.
Truck in the back ground is my buddies truggy build. Bit more extreme then mine here is there build thread on pirate. http://www.pirate4x4.com/forum/showt...ight=yotanator
Truck in the back ground is my buddies truggy build. Bit more extreme then mine here is there build thread on pirate. http://www.pirate4x4.com/forum/showt...ight=yotanator