FS[SouthCent]: 22re 22rte SteedSpeed turbo manifold
Nov 2, 2014 | 12:49 PM
#1
Thread Starter
Registered User
Joined: Jun 2006
Posts: 1,825
Likes: 2
From: austin, tx
22re 22rte SteedSpeed turbo manifold
Parting out my 22RTE conversion... I'm swapping in a 2rz - see the blog
PAYMENT PREFERENCE: Paypal
------------------------------------------------------------------
ITEM: 22RE / 22RTE SteedSpeed Manifold
PRICE: $500
DESCRIPTION:
SteedSpeed manifold. Fits 22RE and 22RTE. Setup for bolt-on 38mm wastegate (you can put a plate over it if you don't have one).
I ran one of Steeds original prototypes, this is my 2nd manifold. It's been on there for a few years, but largely the truck has sat.. Definitely under 20k miles on it and that's being ambitious...
Ceramic coated. A few scratches here and there, but nothing major. No rust. No warping. These manifolds are heavy and take a ton of abuse. All the threads are good - nothing stripped and no surprises. T3 flanged. It was tapped for an EGT sensor (standard 1/2 NPT) - needs a plug if you don't want to run that, available at any hardware store.
LC gets $700 + shipping
$500 shipped to your door.
SOLD.
PAYMENT PREFERENCE: Paypal
------------------------------------------------------------------
ITEM: 22RE / 22RTE SteedSpeed Manifold
PRICE: $500
DESCRIPTION:
SteedSpeed manifold. Fits 22RE and 22RTE. Setup for bolt-on 38mm wastegate (you can put a plate over it if you don't have one).
I ran one of Steeds original prototypes, this is my 2nd manifold. It's been on there for a few years, but largely the truck has sat.. Definitely under 20k miles on it and that's being ambitious...
Ceramic coated. A few scratches here and there, but nothing major. No rust. No warping. These manifolds are heavy and take a ton of abuse. All the threads are good - nothing stripped and no surprises. T3 flanged. It was tapped for an EGT sensor (standard 1/2 NPT) - needs a plug if you don't want to run that, available at any hardware store.
LC gets $700 + shipping
$500 shipped to your door.
SOLD.
Last edited by dcg9381; Nov 3, 2014 at 02:06 PM.
Thread
Thread Starter
Forum
Replies
Last Post
